2008 Honda Accord QuickLIFT System Installation Manual

2008 Honda Accord QuickLIFT System Installation Manual - Step 1 – Unpack QuickLIFT kit and verify contents. Remove all items from the packing tube. You should have the following before beginning: * (2) Gas springs ( RT-QL-200-5A ) – Be sure to cycle them a few times before installing. * (8) 3/16″ #2 Multi-grip Rivets * (4) Steel ball-stud mounting brackets * Printed Color Instructions.
Step 2 – Gather the required tools. Please gather the following tools before you begin the installation: * Power Drill * 3/16″ or indexed #11 drill bits * Fine permanent marker or felt tip pen * Tape Measure or ruler * Masking Tape * Hammer & center punch * Rivet gun, capable of 3/16″ rivets (most brands can handle this size) Note: Only use the rivets supplied in the QuickLIFT system.

Step 3 – Mark centerline of hood bracket location. A. Open your hood. B. Using a piece of masking tape and a permanent marker, carefully measure from the top of the hood’s hinge and measure along the inner hood frame. From the top of the hood’s hinge, measure 15-3/4″ – this will mark the centerline of the hood bracket – offset the bracket 2-1/4″ from the edge of the hood.

Step 4 – Align bracket and mark 1st hole for drilling. A. Align the center of the bracket with the mark you just made on the hood. You will need to view the hood straight on to align the bracket. The bracket should sit on the inner frame with the ball stud facing out or away from the vehicle. B. Holding bracket in place, mark the center of the lower hole using a permanent felt tip marker. Use photos from this step and others to clarify mounting location. C. Set bracket aside. Using a center punch and a hammer, tap the center of the mark you just made (this indention will help guide the drill bit and keep it from wandering). Check placement before continuing.

Download : 2008 Honda Accord QuickLIFT System Installation Manual

Posted in: Honda