2008-2009 FORD FOCUS ELECTRONIC CRUISE KIT 250-1840

2008-2009 FORD FOCUS ELECTRONIC CRUISE KIT 250-1840 - A. Pre-Installation Suggestions 1. It is advisable to disconnect the negative battery cable for 3 minutes before beginning installation, to avoid unintended air bag deployment. Note and record any anti-theft radio codes prior to disconnecting. Figure 1 2. Remove the driver side lower dash and kick panels. Remove the steering wheel shroud. Figure 2 B. Install Electronic Module 1. Apply the large supplied piece of double- sided adhesive tape to the Cruise Control Module. 2. Plug in the Main Wiring Harness, Switch Harness, and Pedal Interface Harness onto mating connectors of the Cruise Control Module.

Figure 3 3. Place the Cruise Control Module in the secure location behind the driver side dash area as shown in Figure 4 . 4. Route the Pedal Interface Harness through steering column and down to the accelerator. 5. Locate the 6 pin plug and mate connectors on the Pedal Interface Harness. Remove the accelerator 6-pin connector and apply to mating connector of Pedal Interface Harness. Apply the other connector to the accelerator. Figure 4 C. Wiring Connections 1. Locate the following wires to connect to the main harness from the control module: 2. Use the supplied self stripping connectors or T-tap to connect from the Main Harness to vehicle wire: 3. Apply the Black Ground Wire from the Main Harness to the Vehicle Ground Point at the kick panel. Figure 7 4. VSS : For reference, find the medal bracket in front of the gray and blue connectors at the center of the engine compartment.

Figure 8 . Locate the gray 2-pin or (3-pin manual transmission) connector on the transmission below the bracket. Figure 9. Note: The 3-pin connector will be covered with foil tape . Connect the Violet Wire from the Main Wiring Harness to the Blue extension wire using the male spade terminal (both supplied in hardware kit). Connect extension harness to Brown/Green Wire (VSS) of the connector. Apply the supplied weather sealant to the connection in the engine compartment. Be sure all of connection is sealed properly. Figure 10 5. Clutch Switch for Manual Transmissions : Locate the black 2-pin connector on the clutch switch. Connect the White Wire from the Main Wiring harness to the Green /Violet Wire of the clutch switch. Secure Cruise Control and Switch Interface Module harnesses with zip ties away from moving parts. Figure 11

Download : 2008-2009 FORD FOCUS ELECTRONIC CRUISE KIT 250-1840

Posted in: Ford