18.14
Unknown
Removing Plastic Plugs 1. Cut off 8 plastic plugs (2 in each corner) with a chisel or knife and push the remaining pieces through the hole using a hammer and nail or punch. Make sure holes are clear. (Fig. 1). 2. Pry 4 plugs out (with a standard screwdriver) of the center of the sides of the truck box (2 each side). (Fig. 2). rail D seal at end of Tailgate Box Seal The torque screws located in the middle of the sides need to be removed according to the instructions. DO NOT REMOVE BOTH SCREWS AT THE SAME TIME. The bracket behind the side wall will fail. Attaching Latch Catch and Keyhole Brackets 3. Place lock washers on screws (12x). (Fig. 3). 4. Place (12) screws with lock washers on, (4) Latch catch brackets (#ST101), and (2) Keyhole brackets (#ST102) into the bed of the truck. (Fig. 4). Mounting Keyhole Bracket 5. Remove lower screw (only the lower screw) using a 30# Torque bit with ratchet. 5. Remove 1 side screw (only the 1 side screw).
6. Place one screw through the lower slot in the keyhole bracket and hand thread into hole where you just removed the torque screw. Then tighten with Phillips screwdriver. 7. After tightening the lower screw, remove upper screw. Then hand thread another screw through the upper slot of the keyhole bracket and into the upper hole where you just removed the torque screw.
Download : Ford Explorer Sport Trac Advanced Folding X5 Supra Cover INSTALLATION INSTRUCTIONS
Posted in: Ford
0 komentar:
Posting Komentar