2006-2007 Buick Lucerne BX1512 Installation Instructions

2006-2007 Buick Lucerne BX1512 Installation Instructions - Attachment Tabs: Due to the design of the removable tabs, the RangeFinderII and Ambassador tow bars can not be used. Adapters, except the BX8833 and BX88151, can not be used with this baseplate. Installation Instructions: 1. Remove four pushpins from the radiator cover and lift to remove. Do this to both sides of the vehicle. Set pushpins and radiator cover aside to be reinstalled later. 2. Remove three pushpins from the top of the fascia. Do this to both sides of the vehicle.

Set pushpins aside to be reinstalled later. 3. Remove five pushpins just forward of the front tire, on the edge of fascia. Do this to both sides of the vehicle. Set pushpins aside to be reinstalled later. 4. Pull wheel well cover aside and remove two metric bolts from back side of fascia using the 10mm socket. Do this to both sides of the vehicle. Set bolts aside to be reinstalled later. 5. Remove four pushpins from the bottom corner of fascia. Do this to both sides of the vehicle. Set pushpins aside to be reinstalled later. 6. Remove two pushpins from the bottom center of fascia. Pull fascia forward to remove. Set pushpins and fascia aside to be reinstalled later. 7. Remove five pushpins from the belly pan.

Set pushpins and belly pan aside to be reinstalled later. 8. Under hood latch area (see inset), disconnect two electrical connections and move out of the way. Using the 13mm socket, remove four metric bolts from the metal bumper. Do this to both sides of the vehicle. Set bolts aside to be reinstalled later. 9. Remove one pushpin fastening the lower section of air dam to the top of the metal bumper. Do this to both sides of the vehicle. Pull metal bumper forward to remove.

Set pushpins and metal bumper aside to be reinstalled later. 10. Mark a rectangle on the lower portion of bumper bracket. Start horizontally below the upper portion of bumper bracket (see white arrow) and continue just beyond the lower bolt hole. Then, mark straight down until reaching bottom of frame rail. This vertical marking should be flush with frame rail edge (behind bumper bracket). Using the reciprocating saw, cut marked area through the bumper bracket and frame rail.
Download :  2006-2007 Buick Lucerne BX1512 Installation Instructions

Posted in: Buick